Window film fitting guide

Our installation instructions will tell you how to fit any of our decorative window films.

You will need:

• Roll of window film
• Scissors/cutting knife
• Tape measure
• Spray bottle containing water with a few drops of washing up liquid
• Squeegee or credit card wrapped in kitchen towel

Method:

1) Thoroughly clean the window the film will be applied to.

2) Cut your film to size of the window, adding an extra 2cm to the width and height.

3) Remove the clear lining film from back of the window film and spray the adhesive back of the film, as well as your fingers, with the soapy water solution. (Tip: If you cannot remove the clear lining film, attach a piece of sticky tape to either side of the film at one corner and peel away from each other).

4) Spray the glass with the soapy water

5) Apply the adhesive side of the film onto the glass and slide into position

6) Spray the face of the film with the soapy water and using a squeegee or credit card wrapped in paper towel, squeegee out all the soapy water from behind the film

7) Trim off any excess film using a sharp knife for a neat finish